At this present time our store location is open by appointment only.

600W RMS

Subwoofer Drivers and Electronics with an RMS Power Rating of 600-Watts

Subs, Speakers and Electronics with an RMS Power Rating of 600-Watts

The RMS rating of any speaker or subwoofer driver is the continuous power rating that the driver is designed to handle at a maximum volume rating. The RMS rating is one of two numbers to go by when pairing your speakers with an amplifier. As an example, a speaker with a 600-Watt, or 600W for short, RMS rating should be paired with a six-hundred-watt RMS amp. We usually recommend a power-plant to be over powered by 10 – 20% RMS so that the amplifier does not have to work at 100% capacity to get 100% efficiency from your speakers.

2 products

  • Alpine S-W10D : 10" 600W Subwoofer Driver, 2Ω or 4Ω DVC

    Alpine S-W10D : 10" 600W Subwoofer Driver, 2Ω or 4Ω DVC

    Pre-Order Today!

    Alpine S-Series 600-Watt 10-Inch Subwoofer Driver, 2Ω or 4Ω Dual Voice Coil Along with the new 8” woofer, the 10” and 12” S-Series subwoofers have been re-designed from the ground up. The mounting depth of the 10” and 12” subwoofers are almost 1” more shallow than previous models at just over 4.5” for the 10” models and just over 5” for the 12” models, allowing them to fit into a wide variety of installation applications. Specifications 10" DVC High Performance Subwoofer Power Handling: 600W RMS/1800W Peak Push-type Insert Terminals with DVC jumper system Concealed Mount Gasket/Grille* System (*Grille sold separately) Frequency Response: 28Hz-200Hz Mounting Depth 4-11/16” Alpine S-W10D2, S-W10D4 Manual

    Pre-Order Today!

    $179.99

  • 600W 10" Subwoofer Driver, 4Ω Dual Voice Coil : JL Audio 10W6v3, shown with grille. JL Audio 10W6v3 : 10-inch 600-Watt Subwoofer Driver, 4-Ohm DVC

    JL Audio 10W6v3 : 600W 10" Subwoofer Driver, 4Ω Dual Voice Coil

    Pre-Order Today!

    W6-Series 10-Inch 600-Watt Subwoofer Driver, 4-Ohm DVC The 10W6v3 subwoofer driver offers several technologies similar to JL Audio's W7AE top line of subwoofers to provide powerful advantages in motor linearity and suspension behavior. This 10" automotive sub has a very efficient cooling circuit to deliver reduced distortion and outstanding dynamic balance. This 10" W6v3 driver is best used with an amplifier in the 200W - 600W RMS range and is optimized to operate in a sealed enclosure with only 0.55 cu. ft. (15.6 l) of air space, or a 0.75 cu. ft. (21.2 l) ported enclosure. The JL Audio 10W6V3-D4 subwoofer driver comes with Dual 4Ω voice coils that allow the 10W6v3 to be installed in a 2Ω or 8Ω configuration. General Specifications Continuous Power Handling 600W RMS Recommended Amplifier Power 200 - 600W RMS Nominal Impedance Dual 4Ω JL Audio 10W6v3 Manual

    Pre-Order Today!

    $799.99

Login

Forgot your password?

Don't have an account yet?
Create account