50W x 2 @ 2Ω

Amplifiers with a Power Output Rating of 50-Watts x 2-Channels, 2-Ohm Final Impedance

Amplifiers with a Power Output Rating of 50-Watts x 2-Channels, 2-Ohm Final Impedance

RMS power: This rating of any amplifier is the continuous power rating that an amp is designed to output at a maximum continued volume rating. The RMS power specification is one of two numbers to go by when pairing your speakers with an amplifier, not the only 2 but a good starting point. As an example, a speaker driver with a 50-Watt, or 50W for short, RMS rating should be paired with a fifty-watt RMS amplifier. We usually recommend an amp to be over powered by 10% RMS so that the power-plant does not have to work at 100% capacity to get 100-percent efficiency from your speakers. This will keep your amplifier from overheating during long periods of continuous operation.

Ohms: Is the resistance rating of an amp and is the second most important when pairing drivers with amplifiers. A power-plant that is 50W @ 2-ohm might only put out 25-Watts @ 4Ω. When purchasing an amplifier, the correct pairing of a speaker’s RMS wattage and Ohm ratings with an amp’s output power rating is absolutely essential.

1 product

  • Kicker 42PXiBT1002 : Bluetooth Equipped Motorcycle Amplifier with Media Controller, All-In-One Stereo Amplifier 50W x 2ch Motorcycle BT Stereo with Amplifier @ 2Ω, 25W x 2ch @ 4Ω : Kicker 42PXiBT1002, settings section.

    Kicker 42PXiBT1002 : 50W x 2ch Motorcycle BT Stereo with Amplifier @ 2Ω, 25W x 2ch @ 4Ω

    Pre-Order Today! - we will notify you when to pick-up or to schedule an installation!

    Bluetooth Equipped Motorcycle Amplifier with Media Controller, All-In-One Stereo Amplifier The PXiBT1002 2ch stereo amplified controller with BT by Kicker is the only solution you need for sound in your side-by-side, ATV, motorcycle, tractor, or whatever your ride. No existing radio necessary. A 24dB selectable crossover with 24dB subsonic filter, made to craft your sound to exacting standards. The Bluetooth receiver allows you to stream music right to the amplifier, while the illuminated display allows you to change track, volume and source. A wide range of input levels make this amp easy to hook up with a factory radio or aftermarket.This PXA amplifier delivers as much as 100 total watts into two channels. See below for more details. Specifications RMS Output @ 4-Ohms 25 watts x 2 RMS Output @ 2-Ohms 50 watts x 2 Length [in, cm] 7, 17.8 Height [in, cm] 1-5/8, 4 Width [in, cm] 3-7/16, 8.7 USB audio input / charging 5V/1A Frequency Response [Hz] 20 - 20k Signal-to-Noise Ratio [dB] 90 Aux Input Sensitivity 500mV Selectable 12dB high-pass crossover OFF, 60Hz, 80Hz, 120Hz RCA pre-out voltage 4.5V RMS

    Pre-Order Today! - we will notify you when to pick-up or to schedule an installation!

    $399.99

Login

Forgot your password?

Don't have an account yet?
Create account